Crane Lifted Climbing Formwork System , Jump Formwork System Platform Width 70cm

1. Climbing bracket

2. Main platform

3. Pouring platform

4. Finishing platform

5. Roll-back system

6. Push-pull prop

7. Vertical waling

8. Anchor system

9. Formwork

Step 1
The first pouring is to be completed by using the proper wall elements and has to be exactly aligned with adjusting struts.

Step 2
The completely pre-assembled climbing scaffold units consisting of climbing brackets with plank bottom and bracing have to be attached to the bracket anchoring and secured.
Then the formwork and the move-off carriage together with the aligning beam has to be positioned on the brackets and fixed.

Step 3
After shifting the climbing scaffold unit to the next pouring position the finishing platform is to be mounted to the brackets to complete the climbing system.

Step 4
Release and remove bolts that fixing the positioning anchor point.
Loosen and remove tie-rod
Loosen the wedges of the carriage unit.

Step 5
Retract the carriage and lock it with wedge.
Install upper climbing cones
Loosen wind securing device, if any
Remove the lower climbing cone

Step 6
Adjust the carriage into the common center of gravity and lock it again.
Attach the crane sling to the vertical waling.
Remove the security bolts of the bracket.
Lift the climbing bracket by crane and attach it to the next prepared climbing cone.
Insert and lock the security bolts again.
Install the wind-load device, if required.

Step 7
Move the carriage back and lock it by wedge.
Clean the formwork.
Install reinforcement bars.

Step 8
Move the formwork forward until lower end rests against top of the finished section of the wall.
Adjust formwork vertically by means of push-pull brace.
Fix tie-rods for the wall formwork