Galvanized Formwork Tie Rod System With Dywidag Thread, Wing Nut and Steel Cones
The Flanged Wing Nut is available in different diameters. With a larger pedestal, it allows a direct load bearing on walings.
It can be screwed on or loosened using a hexagon wrench, thread bar or hammer.
Steel cone is usually used in formwork tie rod system for easy removing the outer tie rod.
Formwork wing nut with flange:
| Flanged Wing nut | Bar Ø (mm) | Plate dia (mm) | Height/Hex. (mm) | Weight (Kg) |
 | 15 | 90 | 55/27 | 0.50 |
| 15 | 100 | 55/27 | 0.62 |
| 15 | 110 | 55/27 | 0.80 |
| 20 | 120 | 60/36 | 1.00 |
| 15 | 64 | 75/27 | 0.34 |
| 15 | 100 | 100/27 | 0.62 |
| Part Name | Specification | Weight (kg) | Remark |
| Tie-rod | D15 D20 | 1.5 kg/m 2.7 kg/m | L=6m; Special length available upon request. |
| Super plate | D15 | 1.28 | Used in case of tie-rod and formwork panels are not vertical. |
| 3-lug wing nut | D15 D20 | 0.97 0.78 | For tie-rod D15; For tie-rod D20 |
| Waling plate | 120 x 120 x 6, Φ19 120 x 120 x 8, Φ19 | 0.65 0.85 | For tie-rod and nut D15; galvanized |
| Water stopper | D15 D20 | 0.55 0.72 | Used in water resistant wall; With tie-rod D15 / D20 |
| Anchor plate | D20 | 0.95 | Embedded in concrete as lost part |
